English Paper Piecing Instructions for using Diamonds

 

 

The preparations are the same as when working with Hexagons or other paper shapes:

 

dia 1

 

 

Place the paper shape on the wrong side of the fabric (pin the paper in place if needed). Cut the fabric patch at least ¼ inch (6-7 mm) larger than the paper using good scissors. It is important to have enough fabric excess to easily cover the paper shape all the way around, remember this is your seam allowance, do not make your life more difficult than necessary!

 

dia 2 dia 3 dia 4 dia 5

 

Fold over the seam allowance along the edge of the paper. Starting in the middle of the edge, stitch through all the layers with big basting stitches (1/4 inch or bigger) along the folded edge.

At the blunt corner of the Diamond fold over the next fabric edge (hold in place) and stitch over the fold (to hold it down, no back stitching needed).

 

dia 6 dia 7 dia 8

 

Continue the baste along the edge, but stop 1/2 inch (1 cm) before the tip of the diamond shape. It is not necessary to tuck under the excess fabric ‘tail’ at the tips. Let your tails wag! Just fold the next edge over and secure with a basting stitch

 

dia 9 dia 10 dia 13 dia 14

Continue to baste around the diamond shape as before. When you reach the other tip tuck the last seam allowance edge under the tail flap. The ‘new’ edge always folds OVER the already basted ‘old’ edge!  This way the ‘tails’ point in opposite directions and come to nestle into nice rosettes on the back of the quilt when the diamonds are sewn together (just fold them out of the way when sewing).

dia 13 dia 14 dia 15 dia 16 dia 17

 

Finish off with an extra basting stitch in the same direction. Alternatively: Weave a few tiny basting stitches through the seam allowance (as shown above) and snip off the thread.

 

dia 18

DONE!

dia 20 dia 21 dia 22

 

To sew two diamonds together (use your pattern for reference), place the shapes right sides together and overcast with small whip stitches just catching the edges of both pieces. About 6-10 stiches per inch (one stitch every 2 mm) will be fine.

 

dia 23 dia 25 dia 26

 

At the end of the seam add another diamond and continue sewing, or (to finish off) do 2-3 backstitches and secure the end of the thread by weaving a few tiny stitches through the seam allowance . Then snip off the thread.

 

dia 27 dia 28 dia 29 dia 30

 

Once patches have been added all around a paper shape, the basting stitches can be removed: Simply snip the basting thread in two places, grab the ends of the thread and pull them out. The paper shape is removed by pincing it in the middle and gently pulling it out. The papers may look worse for wear, but (unless they get torn) they can be smoothed and reused.